How To Remove Foam Double-sided Tape
When some foam double-sided tape needs to be removed in life, people tend to rack their brains for how to remove the double-sided foam, but still have not figured out any way. In the case of this situation, I would like to introduce you to the eight strokes for everyone to easily solve the troubles.
1, can be used to remove the high concentration of thinner, that is, banana water, but the material can not be the surface of the paint material, otherwise the color of the paint may be brushed together. Use the small shovel used to grind the wall to tell the layer of foam attached to the surface of the rubber to scrape off without worrying about scratching. Then use a brush to rub the banana water on the glue after the foam is removed. Let it corrode for a while. After 1, 2 minutes, and then brush with a brush in a circular motion, the glue will slowly fall off. But after the cleaning is more troublesome, and then cleaned with clean water.
2. For the foam glue stuck on the clothes, it can be cleaned with toothpaste. For the foam glue remaining on the door, it can be washed with boiling water.
3. After applying with the oil, apply a little while, then wipe it clean, but this will be oily.
4, use a hair dryer to blow soften the adhesive, which can make its adhesion weak, it can be easily removed. If there is still a little trace, use a degreaser to remove the nail polish.
5, no matter what tape is bonded, the main substances attached are some chemical organic or high-molecular substances, which can be removed by similar compatibility principle. For example, the bonding part of foam double-sided tape can be wetted with 120# gasoline. After a while, it will be removed with a towel, and clean; if there is no gasoline, you can pour a little wine and then wipe it with a towel, but the effect is slightly worse than gasoline.
6. If it is a double-sided foam on the wall. Use an eraser to rub along the edges a little bit and easily remove the marks. But depending on your stickiness, the time may vary. If the conditional alcohol + eraser works well.
7. The double-sided adhesive on the wall can also take a piece of dry cloth covered with vinegar to cover the entire trace of the double-sided adhesive. After the double-sided adhesive is completely wet, it can be easily removed with a ruler.
8, with soap and a little ammonia and turpentine mixture, you can remove a lot of dirt and make the glass surface more shiny (this article applies to tiles, ceramics, glass, etc.).
Household commonly used cleaning agents as well as salt water, kerosene, toothpaste, etc. have a certain effect on the removal of foam rubber traces, but the foam paste is different in material, the cleaning effect is also different, and the traces on the smooth surface are easier to remove. The effect of the cleaning agent used on the foam of different materials is also different. Among them, the cleaning effect of washing powder and saline on the glass is good, and the cleaning effect of kerosene and saline on the blackboard is better.